admin
Assembling a barber chair like a pro might seem like a daunting task, especially if you’re doing it for the first time. However, with the right guidance and tools, you’ll find that it’s not as complicated as it seems. This article will guide you through the process step by step.
Firstly, gather all necessary tools and equipment before starting. Typically, these include screws, washers, bolts, and Allen keys which usually come along with your barber chair package. If they don’t come included in your purchase or are missing some parts, make sure to acquire them separately. It’s also recommended to have an adjustable wrench on hand.
Start off by assembling the base of the chair since this is what supports the entire structure. Securely fasten any nuts or bolts into their designated spots on the base using an adjustable wrench or Allen key depending on what is required.
Once done with securing the base of your Barber Chair properly onto its hydraulic pump (if applicable), proceed to attach the footrest assembly onto it. The footrest often comes in two parts; one part attaches directly onto your chair while another smaller part goes underneath for added support.
Next up is attaching seat assembly to hydraulic pump shaft protruding from top of base assembly – this is where things can get tricky! Be careful when aligning holes between both assemblies because misalignments could lead to stability issues later down line when someone sits on chair.
After successfully assembling seat onto base structure via hydraulic pump shaft attachment point(s), move towards backrest installation phase which typically involves screwing backrest directly into pre-drilled holes located at rear end of seat assembly.
Finally comes armrests installation phase: these are usually bolted directly onto sides of seat assembly using appropriate hardware provided within barber chair package itself – again ensure proper alignment here so that armrests provide sturdy support once fully assembled!
Now that everything has been assembled correctly according to manufacturer’s instructions, it’s time for final checks. Ensure all screws, bolts and nuts are tightened securely – any loose parts can lead to instability or even accidents. Also check that hydraulic pump (if present) is functioning correctly by raising and lowering chair a few times.
In conclusion, assembling a barber chair like a pro requires patience, attention to detail and the correct tools. It might seem intimidating at first but once you get the hang of it, you’ll find that it’s actually quite straightforward. And remember: if in doubt at any point during assembly process – always refer back to manufacturer’s manual or seek professional assistance!
